cisco 路由器 PPPOE
发布网友
发布时间：2022-05-01 07:29
共2个回答
热心网友
时间：2022-06-26 02:49
这里显示的bandwith对实际的带宽并无影响，只要是ADSL拨号，interface dialer 都会显示BW 56 Kbit
如果你担心自己带宽并没有达到4M，可以在本地电信的测速网站是测试一下，或用FTP下载软件找本地电信的FTP服务器测试一下，就知道了
另附上相同的DIALER接口显示
ialer1 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address is 112.215.213.219/32
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Interface is bound to Vi1
Last input never, output never, output hang never
Last clearing of "show interface" counters 13:48:08
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
219585 packets input, 43363911 bytes
215596 packets output, 28326081 bytes
Bound to:
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 13/255, rxload 13/255
Encapsulation PPP, LCP Open
Open: IPCP
PPPoE vaccess, cloned from Dialer1
Vaccess status 0x44, loopback not set
热心网友
时间：2022-06-26 02:50
不知道你的dialer是不是虚拟接口跟以太接口绑定来实现pppoe的?!
